Hỗ trợ kỹ thuật

Design, Selection and Use of TMR Mixers
Introduction

Mixer design is an art.Field testing, consumer feedback and experience is used to refine the design. Despite the information collected over years of use in the beef and dairy industry, and the yearly design changes, mixer design is still a mechanical art form.

Feeding a dairy cow is an art. Total mixed rations (TMR) have become the major feeding system of the dairy industry. Experienced nutritionists and research trials allow us to build better rations. Despite the information collected in research feed trials, and the use of ration balancing software, feeding a dairy cow is still a biological art form.

Mixer Design

 

There are approximately 25 different mixer manufacturers in the market, and in general, the mixers seem to be doing an adequate job of mixing a TMR. There has been only a handful of cases where the mixer design failed to do the job, and those mixers quickly left the market.  In other cases, the mixers were used improperly (over or under mixing) which caused nutritional problems for the dairy herds. The mixer design that works best for one farm may not be the best choice for a different farm. The question “Is there a best mixer design? is open for discussion, debate and personal opinion. A better question would be “Which mixer is better for my situation?”

 

There are certainly design differences in the mixers available. Design changes are driven by market and consumer demand. Take for example the consumer demand that a mixer should be able to handle the addition of long dry hay into the ration. This has impacted the design changes of many of the mixers on today’s market.  In less than 5 years this design goal has produced mixers that can process either a little hay or a lot of hay. This particular design change has caused another potential problem with misuse; particle size reduction with too long a mixing time.

 

Mixer design is still primarily a trial and error process with due consideration given to prior experience.  The manufacturer selects a specific mixer design that is expected to perform and field tests determine design changes and their effect on the mix.


In a summary paper on mixer design, these design and testing issues were identified:

 

· Mixer design (type, geometry, power, time, speed, efficiency)

· Define material changes (particle size reduction)

· Define standards for comparison of mixers

· Classify and measure degree of mixing (determine the quality of the mix)

· Describe the mixing process

· Correlate quality of mix with respect to time

 

All of these are good research projects, and some manufacturers and researchers may have answers to some of these problems. Other issues may not ever be solved.  As an industry, there is no effort to coordinate the research efforts or develop standards for testing.

Nguồn: The dairy site
Ý kiến của bạn
Tên của bạn * :
E-mail * :
Tiêu đề * :
Nội dung * (Bạn vui lòng gõ tiếng việt có dấu):
 
Mã bảo mật * :   
   
Bài viết khác